 |
 |
|
|
Facilities | Certificates
|
 |
|
|
 |
|
Continous improvement of quality, minimizing friction by producing
zero-defect, no-noise bearings, is ORS's main aim. |
|
Advanced Metrology, Metallography and Chemical Laboratories at ORS, are maintained and fully equipped to control material quality. Quality control and measurement at each step of production is the ORS standard.
ORS Quality Assurance laboratories
are TS EN ISO/IEC 17025 accredited subcontractors of Turkish Standards Institute (TSE). |
|
|
|
|
| Metrology
Laboratory |
|
| |
|
Measurements vital for bearing production such as roundness, form and surface roughness are performed around the clock. These measurements for production and calibration of masters are made
according to international standards.
|
|
|
|
|
ORS operates
around the clock, and so do laboratories. Measurements at 20000 X magnification on
roundness values and 150000 X on raceway form and surface roughness, ensure the narrowest
of allowable limits.
|
|
|
|
|
|
Chemical
Laboratory
|
|
|
PH level,
corrosion, stability, nitried, boron, dropping point, flash point, penetration, viscosity
measurements, as well as testing of cutting fluids, conservation oils and greases.
Spectral analysis of greases, oils, emulsions, is done to ensure bearing performance, and
to protect against human health hazards. |
|
|
|
|
|
|
|
Metallography
Laboratory
|
|
|
|
|
Fully equipped and accredited metallography laboratories, inspect all incoming material.
Hardness, chemical composition, microstructure, microcleanliness, and tensile strength,
are all tested. |
|
|
|
|
Engineering
|
|
|
|
Bearings are designed with the
use of sophisticated CAD systems. Customer requirements and
application factors are reviewed by Engineering, and suggestions,
technical information, assembly parameters are readily available.
Engineering is continually researching higher performance
products and manufacturing methods.
|
|
|
|
|
|
|
| ORS
2006 |
|
